Sinus H

– Graphic LCD keypad featuring Multi-keypad function
– Smart Copier device enabling downloading/uploading the operating parameters and the firmware when the inverter is off
– Conduit Kit for cable routing, NEMA1 protection
– Flange Kit for the separation of the air flow for power section cooling.
– Communicator Kit for the conversion of the comms protocol: Modbus/Profibus DP, CANopen, Modbus TCP, Ethernet/IP
– Three-phase input/output inductors
– DC Input inductor
– Braking resistor
– Output ferrites

– Degree of protection IP66 available up to model 0030. Standard version featuring IP20
– Mains disconnect switch integrated into IP66 models
– Optional LCD graphic keypad
– Zero Stack installation
– DC input inductor: integrated into model Sinus H 0034 External DC inductor available for models Sinus H 0001…0030
– Braking module integrated up to model Sinus H 0030
– Overload up to 120% for 60s (Normal Duty)
– Overload up to 150% for 60s (Heavy Duty)
– Overload up to 200% for 4s
– Operating temperature with no derating: -10°C up to 50°C depending on the type of overload
– Integrated RS485 serial port, MODBUS RTU communications protocol
– Integrated EMC filter: type A1 or A2 depending on the model
– Integrated Safe Torque Off (STO) function. Certified according to EN61508, SIL2 and EN ISO 13849-1, PL d
– Standard compliance: RoHS, CE, EAC, RCM and UL

– Integrated control methods: V/F, Sensorless Vector Control and Sensorless Permanent Magnet Motor Control
– Integrated PLC function: up to 18 programmable logic blocks
– Energy Saving function
– Lifetime Detection (capacitors and fans)
– High torque even at low frequency values, 200%/0.5Hz
– Multi-keypad function available with graphic LCD: enables controlling multiple devices from a single keypad
– P2P (Peer to Peer) communications
– Selectable motor autotuning: when stopped or when running
– Compatible with the “REMOTE DRIVE” software for the remote control of the device